WRT54GS v3

Discussion in 'DD-WRT Firmware' started by EnigmaX4, Aug 25, 2005.

  1. EnigmaX4

    EnigmaX4 Network Guru Member

    What 3rd Party Firmware can I use on my wrt54gs v3
  2. 4Access

    4Access Network Guru Member

    DD-WRT should work. Also I believe the new HyperWRT based on 4.70.6 (mentioned on the front page here) should work as well although I can't swear to that right now.
  3. BrainSlayer

    BrainSlayer Network Guru Member

    not do fast. its not tested. i can't get a testunit here
  4. fonsch

    fonsch Network Guru Member

    Hello dispense my English but I come from Argentina and I do not speak it ( neither I write it ) very well.
    Want knowing if exists some firmware for wrt54gs V3 ( or if it cans with the original firmware ) that it permit to connect me with another wrt54gs V3 in order to lace two nets and to share internet.

    The scheme would be like this

    router--> switch (with lan1) --> wrt54gs v3 ))))))) wireless((((((((( wrt54gs v3 ----> lan 2

    I read on somewhat so-called WDS but I am not sure .
    From now on thanks and know dispensing my horrific English.
  5. cyberseb0

    cyberseb0 Guest

    You can do it with the original firmware.

    you have to make a bridge between your two Wireless AP. It's very simple.

    Good Luck.
  6. BrainSlayer

    BrainSlayer Network Guru Member

    dd-wrt v23 will support v4 g and v3 gs before final release. currently i'm searching for the testunits
  7. fonsch

    fonsch Network Guru Member

    Ok, thanks cycberseb0, now I am going to look for the mode to do it ( for googl....) ; )
  8. fonsch

    fonsch Network Guru Member

    I had a talk with Linksys's representative he told me that there is no form to do a bridge among wrt54gs. Then like do I do it?
  9. Mr_X

    Mr_X Network Guru Member

    The linksys representative is right and wrong. You can't do it with stock firmware but with alternative firmware like dd-wrt it is possible.
    I'll do that later and I was told it is possible, someone already done that before:
  10. fonsch

    fonsch Network Guru Member

    Ok but. it possible to place the ddwrt on a wrt54gsV3?
    Else it cans ... You know some other firmware's type for that router (v3) that he make wds.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice