WRT54GS v5.1 problem

Discussion in 'DD-WRT Firmware' started by liamf91, Jul 8, 2008.

  1. liamf91

    liamf91 Addicted to LI Member

    Hi i have the Linksys WRT54GS v5.1, and i decided to install the DD-WRT firmware so i could use in on my xbox 360. Everything worked fine for several months until today i tryed using it and it doesn't seem to be doing anything, the power light, ethernet lights (all four) and the internet light is switched on and solid. When i connected it to my pc it doesnt respond and has the "A network cable is unplugged" message. I've tryed shorting it with with 5/6 and 15/16 pins but i guess thats for older versions and it didnt work with this one.
    Can anyone help me with this problem? thanks
  2. CaNsA

    CaNsA Network Guru Member

    Its a very bad idea to start shorting pins on the 5.1.

    The pin layout will not be the same as previous versions.

    Is more than likely u have fried your router.

    set your computer ip to
    turn off the router
    start/run/cmd to bring up a command prompt.
    ping /t

    hit enter
    turn the router on.

    If you get any replies u may be able to save it by tftp-ing the firmware back on it again.

    let me know what happens.

  3. liamf91

    liamf91 Addicted to LI Member

    no, just says "destination host no reply" dont acctually think that they are communicating because there is no change when it is connected. have you anymore ideas
  4. CaNsA

    CaNsA Network Guru Member

    nopes, loox like its fried matey.

    My mate needs a new case for his though, If u havent got any plans for it can i have it?
  5. liamf91

    liamf91 Addicted to LI Member

    orte ok thanks anyway. and the case i snapped when i was attempting to get to the board so its not really worth having sorry.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice