wrt54gs v7

Discussion in 'Cisco/Linksys Wireless Routers' started by vortec53lk, Jan 3, 2008.

  1. vortec53lk

    vortec53lk Guest

    how can I tell if I have the intel chip or not? I've read that you have to flash differently if you have the intel chip. my serial number = CGNC1xxxxxxxx. I would like to install dd-wrt, but don't want to brick my good router. any help will be appreciated
    thanx




    [DD-WRT v24 RC3] The WRT54GS v7 is now fully supported (if its not an intel chip - see important note below), but requires again a special flashing way, which is easier this time compared to the v5 and v6 vxworks killer.

    WARNING: There are at least two types of flash chips that are used on the v7 router. Using this method with an INTEL-type flash chip will brick your router. There is not currently a solution for using vxworkskiller with the intel-chip v7 routers.
     
  2. frenchy2k1

    frenchy2k1 LI Guru Member

    I guess you will have to open the case and look.
    Flash chip manufacturers are written on the chips themselves.
     
  3. n9lya

    n9lya LI Guru Member

    Chip Set

    I will have to look but I thought within DD-WRT it listed the chipset.....

    At least I think I saw mine listed there on one of the pages..

    JK
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice