WRT54GSv1.0 Signal & Noise

Discussion in 'Cisco/Linksys Wireless Routers' started by Maxx, Mar 11, 2005.

  1. Maxx

    Maxx Network Guru Member

    Here goes:

    WRT54GSv1.0 @ Firmware Version: v3.37.6 - HyperWRT 2.1b1 using 5.5dBi-gain antennas (360deg horizontal transmission pattern, 50deg vertical transmission pattern; Frequency Range: 2400-2485MHz, VSWR 1.5:1, Impedence: 50ohms, Input Power: 10W)
    WMP54GSv1.0 @ Driver Version: 3.50.21.11 EU
    WPC54GSv1.0 @ Driver Version: 3.50.21.11 EU

    Note: Both NICs using Linksys Wireless Networking Monitor v4.0

    WMP54GSv1.0 (0 walls and less than 2m away, directly beneath the router)
    reported Noise Level: -88dBm
    reported Signal Strength: -53dBm

    WPC54v1.0 (about 2 walls and 15m away, directly ahead of the router)
    reported Noise Level: -88dBm
    reported Signal Strength: -72dBm

    How do these (noise and signal) specs look to you? BTW, I realize that placing the WMP54GS beneath the WRT54GS is NOT a good idea and might be causing some problems. Any quick solutions assuming I can't change the location of either piece of hardware?

    PS - I've got an RMA on this (v1.0) particular GS router (the new one should be v2.2 of the WRT54GS - so says Linksys - and will be in next week) as it has been giving me all types of problems (vide my other posts).
     
  2. Maxx

    Maxx Network Guru Member

    ???
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice