wrt54gx v (not quite sure)

Discussion in 'Cisco/Linksys Wireless Routers' started by agent1192, Nov 3, 2005.

  1. agent1192

    agent1192 Network Guru Member

    I have a client with a wrt54gx with 3 removable antennae. So this would commonly dictate a v2 router. When i try to update firmware it states incorrect version. Sure enough access through web interface and the firmware says 1.02.06. Version 1 firmware on a version 2 router? Am I incorrect in my assumptions here or is this just weird. Anyone seen this before? Solution? Unit is dropping WAN with heavy load or after several hours. I will exchange unit if this is just a bad unit. Just verifying I am not on drugs here.
     
  2. howardp6

    howardp6 Network Guru Member

    WRT54GX v1 had firmware version 1.02.06 and the antennas was non-removable. WRT54GX v2 has antennas were removable with R-SMA connectors and firmware version 2.00.5. What version does the label and FCC-ID indicate? You either have a late version 1.0 with removable antennas or an early version 2.0 with version 1.0 firmware. Very strange indeed. 8O
     
  3. wkaml

    wkaml Network Guru Member

    I had the same error when I tried updating a EU model of the WRT54GX-v2 with the US firmware. You need to make sure that
    a) you have a US version of the router
    b) the firmware you are trying to upload is a US version as well.
    Check the labels at the bottom of the router or try opening the routers page /fw_id.htm.
     
  4. agent1192

    agent1192 Network Guru Member

    firware revision on router page says version 1
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice