1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

[WRTG54G] - Apply saved config file from v8 to v8.2 ???

Discussion in 'Cisco/Linksys Wireless Routers' started by graffixx, Apr 17, 2008.

  1. graffixx

    graffixx Guest

    I had to RMA my WRT54G v8 to Linksys because the LED lights on ports 1, 3, 4, and Internet would stay lit when powering the router on WITHOUT anything else plugged in. The Power LED light stays OFF.

    We recently bought a few more of these WRT54Gs at work, so I'm borrowing one. It's v8.2.

    Can I apply my saved config file from v8 to the v8.2? Would that work?
     
  2. davexnet

    davexnet LI Guru Member

    There's a risk, however small. It;'s up to you if you want to take that risk.
     

Share This Page