wrtsl54gs+thibor17rc3: edit smb.conf

Discussion in 'HyperWRT Firmware' started by mw1001, Jul 23, 2007.

  1. mw1001

    mw1001 Network Guru Member

    Hi,

    How can I edit and save (keeping the changes) from smb.conf file?
    I have edited the file /tmp/samba/lib/smb.conf to set the dos charset to cp850. After exit from vi, if I open the file again, the changes are ok. But whensamba is restarted file switch back to the one before the edit.


    In time: running thibor 17rc3

    Thanks in advance.
     
  2. plugh

    plugh Network Guru Member

    It is re-written from code, so can't be done that way.

    In a personal build, I added a bit of code in that area that would write the value of a nvram variable near the top of the file when it is created. Then I simply set the nvram variable to the text line(s) I wanted to insert.

    Perhaps Thibor could be convinced to add something similar in a future build...
     
  3. plugh

    plugh Network Guru Member

    Addendum:

    I also vaguely recall someone posting a method of modifying smb.conf via the "firewall script" (?) - apparently it runs at just the right time...

    I think it was over in the hyperwrt forum (which I haven't been able to get to for a while).
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice