1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WRV200 to Cisco 871 VPN

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by engelbert, Jan 15, 2008.

  1. engelbert

    engelbert Guest

    Hello, have been trolling looking for someone who has set up Remote WRV200's that IPSEC to a Cisco. I set up Easy VPN and am able to vpn using the cisco client.

    But I get this error in the vpn log of the wrv200
    protocol/port in Phase 1 ID Payload must be 0/0 or 17/500 but are 17/0

    I also assume that there is no way to do client (Xauth) authentication correct?

    Has anyone gotten this to work appropriately? I would like to give the WRV200 to sales people so that the devices can establish a vpn automatically when needed.


    Below is the 871 config that is pertinent

    crypto isakmp policy 1
    encr 3des
    authentication pre-share
    group 2
    crypto isakmp key iforgot1 address 0.0.0.0 0.0.0.0
    crypto isakmp client configuration address-pool local SDM_POOL_1
    !
    crypto isakmp client configuration group default
    key iforgot1
    dns 10.1.0.20 10.1.0.1
    wins 10.1.0.20
    domain local.local
    pool SDM_POOL_2
    acl 102
    crypto isakmp profile sdm-ike-profile-1
    match identity group default
    isakmp authorization list sdm_vpn_group_ml_1
    client configuration address respond
    virtual-template 4
    !
    !
    crypto ipsec transform-set ESP-3DES-SHA esp-3des esp-sha-hmac
    crypto ipsec transform-set ESP-3DES-SHA1 esp-3des esp-sha-hmac
    crypto ipsec transform-set ESP-3DES-SHA2 esp-3des esp-sha-hmac
    crypto ipsec transform-set ESP-3DES-SHA3 esp-3des esp-sha-hmac
    !
    crypto ipsec profile SDM_Profile1
    set transform-set ESP-3DES-SHA2
    set isakmp-profile sdm-ike-profile-1


    Thank you very much for all of your help and replies!

    WRV200. 1.0.32.2
     
  2. DocLarge

    DocLarge Super Moderator Staff Member Member

    I've successfully configured a tunnel between a WRV200 (firmware 1.0.37) and a cisco 871w. I haven't gotten around to trying the ez vpn setup as of yet, but if you're interested in the type of config I'm referring to, here's the link:

    http://www.linksysinfo.org/forums/showthread.php?t=54220
     

Share This Page