WRV200 VPN tunnel to WRV200 help

Discussion in 'Networking Issues' started by i8theburger, Feb 19, 2008.

  1. i8theburger

    i8theburger LI Guru Member

    This is my first post. I have been searching the internet and this site in particular for help on setting up a VPN tunnel between two WRV200s. I have a central location to which I would ideally lke to connect four satelite operations via VPN and have network storage at teh central location. Through my reasearch I have managed to set up just two of the routers such that they can see one another according to the GUI but I cannot get the networks to talk.
    Can anyone point me in the direction of a step by step VPN setup for these routers?
    I called linksys and after being on the phone for an hour I was told a senior programmer would call me back and I never got that call.
  2. Toxic

    Toxic Administrator Staff Member

  3. i8theburger

    i8theburger LI Guru Member

    Thank you for the quick reply. I have followed the tutorial for this router and I will set up the other when I get home. I will let you know how it goes. Thanks again!
  4. i8theburger

    i8theburger LI Guru Member

    Step 1 complete! So the two routers say they are connected now. And I can ping the router at the opposite end with success.

    So how do I set up the networks to talk to one another? When I go to networks here, I can still only see the local computers and printers.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice