1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WRV200 + WAP problem

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by denzl, Dec 21, 2007.

  1. denzl

    denzl LI Guru Member

    I have such problem;

    I have WRV200, on wich are connected 2 computers + VPN. On other side like had another from Linksys device for Repeat Signal. On this side i tested to device WAP200 and WAP54G, but this works only in case, if protection is turned OFF. If is turn ON WEP, WPA or WPA2, doesn't work!
    The problem is this, that device on the other side of, that wish for durning WAP200 or WPA54G to connect on internet, IP doesn't get address! ( or NO IP!
    The WDS settings are correct, because the devices between self see. All 3 devices am already updated with last offical Linksys Firmware, but nothing helps.

    If me knows here who to help to age for beer! :smile:

Share This Page