1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WRV200 WDS Question

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by chris_oakes, Jul 30, 2008.

  1. chris_oakes

    chris_oakes Guest

    I need to add a repeater to a WRV200 and according to the note at the bottom of the WDS page in the firmware it says:

    Note: The WDS feature allows WRV200 to connect with up to 3 wireless repeaters that can be either WAP54GP or WAP54GPE.

    Does this mean only these may be used because that brings up another issue. This is from the users guide on the WAP54GP device:

    IMPORTANT: For Wireless Repeater and Wireless Bridge modes, the remote access point
    must be a second Linksys Wireless-G Access Point with Power Over Ethernet (model
    number: WAP54GP) or a Linksys Wireless-G Exterior Access Point with Power Over Ethernet
    (model number: WAP54GPE). The Access Point will not communicate with any other kind of
    remote access point.

    Am I reading these correctly or is Linksys not aware of what their own products will do? Has anyone added a repeater to the WRV200 successfully and if so what device did they use?
     

Share This Page