1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WRV54G-WRV54G Tunnel and Network Drive Maps

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by wineguy, Dec 28, 2006.

  1. wineguy

    wineguy Network Guru Member

    I'm almost embarassed to have to make this post, but I have two 54G's connected in a VPN point to point tunnel. I can access my cameras by IP address with no problem, but can not map to the C: drives on the computers behind the other endpoint router. But, if I shut down the tunnel and use quickvpn, I can access the cameras and map to both c: drives on the two networked computers.

    I'm sure I'm overlooking something on the tunnel setups on the routers, but I've tried everything that makes sense. I'm hoping someone here has run across this and maybe has a solution that doesn't make sense, but works. One 54G is running 2.37.13, the other is running 2.38. Haven't tried to harmonize the firmware, but that is one of those that doesn't make sense to me.

    Scott
     
  2. TazUk

    TazUk Network Guru Member

    I would update both routers to the latest firmware, which is 2.39.2, as that will most likely fix it :)
     
  3. computerwise

    computerwise Guest

    I found this solution after hours of googling at:
    http://www.dslreports.com/forum/remark,15771966
    This worked and I now have my two WRV54G 's talking to each other and mapping drives. Stupid Microsoft :mad:

    Hope that helps someone else!

    -Brodie
     
  4. wineguy

    wineguy Network Guru Member

    It's a beautiful thing! Drives map across VPN now. Thanks for sharing what you found. I'm actually using windows XP home on a new Intel Imac, everything now works using either bootcamp or parallels.

    Scott
     

Share This Page