WUSB54G v4 NetStumbler Signal/Noise

Discussion in 'Other Linksys Equipment' started by zapple, Dec 11, 2005.

  1. zapple

    zapple Network Guru Member

    Hi
    I have a WUSB54G v4, NetStumbler detects all the Ap´s but cannot read the signal/noise. Do you know what is the problem?
    theorically must work http://www.stumbler.net/compat/
    regards
     
  2. Hemingray

    Hemingray Network Guru Member

    It finds APs? I tried netstumbler with my WUSB54G v4 and only got "no APs active" even though I was right next to my WRT54G with it.
     
  3. zapple

    zapple Network Guru Member

    Yes works finding AP´s, but does not work with the signal/noise monitor.

    Wirelessmon from PassMark software works really Great!
     
  4. tgillett

    tgillett Network Guru Member

    noise monitor

    I saw a note in the NetStumbler release notes about devices that use NDIS5 drivers not being able to monitor the noise figure.

    My WUSB54GP shows up in Netstumbler as having a NDIS5 driver., so I figure it won't show a meaningful noise figure.

    On mine it shows SNR 50 or 52 when it can occasionally see the AP (see discussion below).

    Other figures are:
    Signal+ is 14
    Noise- is 100
    SNR+ is 86
    These don't seem to change or be dependent on whether it can see the AP.

    Hope this helps (not sure what it all means!)

    That said, I can't get my device to work. It intermittently sees my AP in the Linksys Montor program's site survey, but won't connect from the site survey page or from a defined profile.

    In NetStumbler it intermittently sees my ap with gaps of minutes.
    Same in WirelessMon.

    My AP is a Billion 7402VGP and it works just fine with my Dell laptop fitted with a Minitar Cardbus wireless adapter.

    Any suggestions welcome.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice