1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Yes or No question/answer

Discussion in 'HyperWRT Firmware' started by drunknmunky, Mar 17, 2007.

  1. drunknmunky

    drunknmunky Network Guru Member

    Hey guys
    I have a WRT54G
    I would just like to know if there is any way to cap the speeds or feed going to computers connected to the router via a wireless connection.

    could i reduce the transmission rate or modify some of the advanced wireless settings to do so?

    thx

    Billy
     
  2. ifican

    ifican Network Guru Member

    No, but what are you trying to do and maybe we can help figure something out.
     
  3. Disman_ca

    Disman_ca Super Moderator Staff Member Member

    Actually you probably could with HyperWRT if you set a QoS definition based the MAC address of the WiFi client. Just set the MAC and then choose the priority but this would only limit the amount of traffic it can consume based on who else is on the network at the same time. It won't cap the download/upload total amount.
     
  4. frenchy2k1

    frenchy2k1 LI Guru Member

    actually, if you agree to lower the speed of all connected devices, you can just choose a minimum speed wirelees connection (1Mb).
    This would force all client to connect to your router at that speed.

    Of course, if you are trying to limit their connection to the internet through the router, this won't help that much, as this stays quite fast compared to cable/DSL speed.
     

Share This Page