1:1 nat possible?

Discussion in 'Tomato Firmware' started by spliff, Feb 26, 2009.

  1. spliff

    spliff LI Guru Member

    Is 1:1 nat possible with Tomato 1.23 (Victek's build)?

    I would like to run virtual machines on my internal network and use 1:1 nat to make them accessible from the net.
  2. spliff

    spliff LI Guru Member

  3. cpu2k

    cpu2k Guest

    NAT is set from your VM software... just set it to network bridge mode and the VM will get an IP from the router... you can then forward your ports to that IP...
  4. humba

    humba Network Guru Member

    What do you mean by 1:1 NAT?
  5. ifican

    ifican Network Guru Member

    This looks very similar to another thread from just a couple days ago. But if you mean true 1:1 NAT you would have to have multiple ip's in the same wan subnet from your isp and create multiple virtual wan interfaces on tomato. Once you get that part done you will have to figure out the correct nat settings. But i do not see any reason it cannot be done, just going to take some work and not something that is going to be done via the gui.
  6. spliff

    spliff LI Guru Member

    Yes I have 5 IPs from my ISP and I want to be able to forward each IP to an internal address.
  7. spliff

    spliff LI Guru Member

  8. spliff

    spliff LI Guru Member

    I did the steps in the DD-WRT wiki and they worked. They should probably go on the Tomato wiki too.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice