1.4g upgrade failed

Discussion in 'HyperWRT Firmware' started by Lestat, Dec 16, 2004.

  1. Lestat

    Lestat Network Guru Member


    I flashed my WRT54Gs witht the 1.4_g firmware but now it refuse all other firmware except the 1.4g into the firmware upgrade on the web interface...

    It begin then after 2 line it put "upgrade failed"

    I have try with: HyperWRT_2.0b3_GS, Firmware_Satori-4.0GS, wrt54gs_2.07.1_US_code and WRT54GS_3.37.2_US_code

    I tryed the reboot (reset for 30 secs) but nothing changed...

    I need the best firmware for use 2 WRT54GS together (AP-Client)...

    So any idea how to change the firmware even to 2.03b or to satori that was working before?
  2. Avenger20

    Avenger20 Network Guru Member

    You might want to try to tftp satori_g firmware in on bootup

    * Download Satori for G and rename it to code.bin
    * Connect your router to your computer, putting the ethernet cable into a LAN port.
    * Set the manual IP "" on your computer.
    * Start command prompt on windows, go to the "code.bin" directory and type "tftp -i put code.bin" and do NOT press Enter yet.
    * Cold boot the router and in the period between the "all lights flashing" (with "boot wait" set to "on" this will be 5 seconds, with "boot wait" set to "off" only 1 second) press Enter on your computer.
    * When your computer says successful, wait another minute until the router reboots itself
  3. Lestat

    Lestat Network Guru Member


    Thx it worked :wink:

    But I got a tftp.exe that have a windowed interface... So I rebooted the router and just after the "all light flash" I pushed update and it do it... :D
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice