2 54g's and wired clients not connecting to 2nd 54G

Discussion in 'Sveasoft Firmware' started by takeitblack, Aug 23, 2005.

  1. takeitblack

    takeitblack Network Guru Member

    Ive set up the 54G's using the guide, and I believe that they can both see each other in the status screen.

    I dont have any wireless clients yet.

    I just dont get how to connect a wired connection to the second 54G with DHCP disabled.

    Help please?
  2. howardp6

    howardp6 Network Guru Member

    Which way are the two WRT54G routers connected. If they are wired together, you have to connect one of the LAN ports on tthe second WRT54G to one of the LAN ports of the WRT54G that is acting as the gateway and you should power cycle both routers. If you are connecting with WDS, and are using Sveasoft Achemy, you have to have a DHCP server or DHCP relay on the LAN of second WRT54G.
  3. takeitblack

    takeitblack Network Guru Member

    They are connected wirelessly.

    I have enabled WDS and in the status screen --> wireless it will show the other router.

    Where would I enable dhcp on the second router? I thought it only needed to be enabled on the first...Is this b/c it is for a wired port?

    Do I need a diferenct range of ips for the wired ports?
  4. takeitblack

    takeitblack Network Guru Member

    So does anyone have a response?
  5. takeitblack

    takeitblack Network Guru Member

    I got it working right.

    Reset and re entered information and powercycled a few times and it ended up working.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice