Access to Modem Webinterface

Discussion in 'General Discussion' started by WarCow, Mar 23, 2005.

  1. WarCow

    WarCow Network Guru Member


    I have a modem with webinterface connected to the WRT54GS (standard firmware). Without the router it is possible to acess the modem webinterface. But with the router connected it is no longer possible to access this webinterface. Is it possible to set some route so I can access both modem and router webinterface?
  2. TazUk

    TazUk Network Guru Member

    What modem is it?

    What IP address is it on?

    What IP range are you using on your local LAN?
  3. WarCow

    WarCow Network Guru Member

    Zyxel 642R

    local IP range +
    router on
    modem on
  4. howardp6

    howardp6 Network Guru Member

    The Zyxel 642R is a one port ADSL modem/router. It has a DHCP server. You can connect through the serial port and use Telenet to configure the router/modem.

    Which is the gateway the Zyxel ot the WRT54G?

    Do you have the Zyxel 642R setup in bridge mode with the DHCP server disabled and do you have the WRT54GS setup to handle the PPOE logon or do you have the Zyxel 642R set up to handle the PPOE. DHCP server enabled and the WRT54G set to DHCP client with the DHCP server disabled on the WRT54G?

    As for web access, that would be difficult, since it has only one Ethernet Port.

    Try this, if you assigned a static ip address to your computer and designated your computer as a DMZ, whether you could access the Zyxel by its IP address and you can turn off the NAT
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice