Address to connect FreshTomato

Discussion in 'Tomato Firmware' started by Olivier, Feb 2, 2019.

  1. Olivier

    Olivier New Member Member

    Dear all,

    I have receive my new WNR500Lv2 today and upgrade it with "MIPS R2-138 K26 USB AIO".

    Router seems not to be bricked but I can't connect "192.168.1.1" ...

    What's the default address to access the router ?

    Regards

    Olivier
     
  2. txnative

    txnative Addicted to LI Member

    The ip address should be 192.168.1.1. Have you setup a static ip to check if you can connect to it?
     
  3. Olivier

    Olivier New Member Member

    When I received it, the ip to connect netgear genie was 10.0.0.1, I didn't change anything on it and just update the firmware to the tomato one.
    Now, I would like to connect it for the time but this is impossible.
    I didn't connect it to the network, just one computer on it.

    To configure my first WNR3500 2 years ago, I proceed the same and it worked.
     
  4. txnative

    txnative Addicted to LI Member

    See if you can reset the router. Usually by unplugging the power, hold the reset, plug the power in, hold the reset button 15 seconds then release the button. Wait for at least 3 mins, 192.168.1.1 is the ip address, login:admin pass:admin the indicator lights should be on. Before flashing a router, you would need to reset the router before installing any firmware. Good luck
     
  5. Olivier

    Olivier New Member Member

    Fine, thx ! I connect the interface !
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice