Adjusting WDS tolerance on WRT54G in OpenWRT

Discussion in 'Networking Issues' started by erratio, Dec 8, 2008.

  1. erratio

    erratio Addicted to LI Member

    I'm presently trying to optimize a 3 router WDS (a mix of WRT54G & WRT54GL). 2 of the routers are near each other and have no connectivity issues, but the 3rd is separated a bit (the distance isn't enormous but there's a bit of a maze through concrete). The network was originally deployed using DD-WRT but then was switched to OpenWRT. The 3rd router then had to be switched back to DD-WRT because OpenWRT would drop the connection while DD-WRT just slows.

    The connection gets bogged down seemingly during times when there would be a decent amount of interference. OpenWRT would invariably work fine after rebooting but then would drop the connection again. I've tried swapping around the routers, narrowing the issue to software. I have a 4th router for testing which is running OpenWRT which I hope to use to replace the 3rd router, but need to determine how to configure OpenWRT to handle the network issues at least as well as DD-WRT. Any guidance would be greatly appreciated. I'm beginning to go through the various wl commands available but have little experience with radio.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice