Advanced static routing

Discussion in 'Networking Issues' started by tay829, May 13, 2006.

  1. tay829

    tay829 LI Guru Member

    I have a BEFSR41 v2 FW: 1.45.7 and a WRT54GL FW: v4.30.0 connected to the BEFSR41 for internet gateway.

    The BEFSR41 is set for Class C scheme and DHCP upto 129 hosts. I have set aside host 130 static IP for my CRM server. This router is also directly connected to my DSL modem.

    I have the WRT54GL set to Class C DHCP. I have set up the default gateway so I can have access to the internet through the BEFSR41.

    My problem is I want to share network resources between the two networks, but I have been unable to do so. I check and they state it is possible, but not in the scope of their support. Can anyone please advise.

    I have setup static routing between the routers:

    WRT54GL to BEFSR41:
    Operating mode: Router
    RIP: Both
    Interface: I have tried both.
    Destination LAN IP:
    Default Gateway:

    BEFSR41 to WRT54GL:
    Destination LAN IP:
    Default Gateway:
  2. reber

    reber Network Guru Member

  3. tay829

    tay829 LI Guru Member


    I have been able to setup the WRT54GL with static routing and access network resources on the BEFSR41 side, but not vice versa even though they are configured the same way as far as which settings are implemented? I will give the link you provided the once over and see if that will answer any questions.
  4. NolanWNET

    NolanWNET Network Guru Member

    Try turning the firewall off on the GL...
  5. tay829

    tay829 LI Guru Member

    Firewall off.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice