After Sartori upgrade, unable to access router

Discussion in 'Sveasoft Firmware' started by thedoctor, Dec 10, 2005.

  1. thedoctor

    thedoctor Guest

    I have upgraded the firmware in the WRT54G router so as to be able to increase the power of the wireless connection. Everything is fine but I cannot access the router (typing into the Address bar of IE). Is there another address which I should be using with the new upgrade?? The 'ipcong /all' command yields '' and '' Can anyone help??

  2. Flashing Satori...
    Trying to increase the power...
    Using IE...

    These are all things that are considered to be Very Stupid[tm]
  3. Disman_ca

    Disman_ca Super Moderator Staff Member Member

    Hold the reset button for 30 seconds then wait for the router to finish booting up. This will reset it to default values. Also make sure you open a new browser window as the current browser session has expired. Also remove the power and apply power again.

    @firmwaredownload: nice help. Incase you didn't know, forum members usually try to help when they post a response to a thread.
  4. thedoctor

    thedoctor Guest

    Sartori & WRT54G router


    Many thanks for your advice. Haven't tried t yet but will do so soon. Will the rest remove the Sartori firmware?? May I ask your comments later if I continue to have problems??

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice