Anybody have a bridge, or client mode, working with WPA?

Discussion in 'Cisco/Linksys Wireless Routers' started by photoman, Jul 28, 2005.

  1. photoman

    photoman Guest

    I have a WRT54GX router running WPA. I need to connect a printer using a bridge or router (in client mode). Does anybody know of a solution that works? I have tried three bridges that say they support WPA but they don't. They work fine with WEP, but fail with WPA.


  2. howardp6

    howardp6 Network Guru Member

    Jerry, which firmware version are you running on the WRT54GX. If you have version 1.0 of the WRT54GX and are using firmware version 1.02.6 WPA-2 only use both WPA and WPA-2. If you have version 2.0 of the WRT54GX, do the same. The WAP54G with firmware version 2.08 supports WPA-PSK in both bridge and repeater mode, but it only supports WPA not WPA-2.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice