Automaticaly connect to PPPoE

Discussion in 'Cisco/Linksys Wireless Routers' started by crocodilu, Jan 8, 2006.

  1. crocodilu

    crocodilu Network Guru Member


    I have a WRT54G v3.1 with v4.30.1, HyperWRT 2.1b1 +tofu11 firmware. It works almost perfectly but I have one little problem.
    From time to time the router disconects from my ISP (I use PPPoE) and I have to click on CONNECT from the status page.
    The question is if this can be done automaticaly. If the link failes, the router should try to connect to the ISP by itself (how? ) and always remain connected (this can be done, using keep alive).

    Thank you.

    PS. I am quite sure that the router disconects because of the ISP and not because it's broken or something.

    PS2: Connect on demand solves the problem, but only 99%, because if I don't have any trafic and the link failes, the connection will not start up again.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice