Bad throughput with two WET54Gs

Discussion in 'Other Linksys Equipment' started by devdog55, Jul 6, 2005.

  1. devdog55

    devdog55 Guest

    I have two WET54Gs set up in adhoc to connect my house to work. It is a little less than a mile between the two. I have a 24dbi parabolic at each end, I know the alignment is good because if I use two DWL-810s I get an actual throughput of 5mbps. Also the WET54Gs are showing a signal strength of 100%. My actual throughput is only 1.3mbps no matter how I set them.

    Any help would be appreciated
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice