Bandwidth Limitation As a percentage of connected clientsq

Discussion in 'Tomato Firmware' started by enema, Apr 14, 2010.

  1. enema

    enema Networkin' Nut Member

    Hey, I'm new to the forum and was wondering if anyone could solve a problem I'm having. I would basically like to distribute bandwidth limits evenly between users that are actually connected to the router. so say if 3 people were connected they would receive a flat 33% of the bandwidth each, or 50% for 2 etc.

    I'm currently using Tomato RAF firmware on a wrt54gl router but to no avail.

    thanks in advance :)
  2. Mercjoe

    Mercjoe Network Guru Member

    This would be a dream feature for me.

    You can use the WRT rules generator to make a close approximation, but as far as I know, a division of bandwidth per client on a dynamic basis is not possible in the current firmware.

    Here is a link to the rules generator:
  3. Azuse

    Azuse LI Guru Member

    I thought the mac limiter scaled bandwidth until one of the set limits was reach, then guaranteed that while dividing the remainder. At least with 2/3 users I've found it sharing bandwidth evenly but it could be a placebo :)
  4. Armand1234

    Armand1234 Addicted to LI Member

    Did any of you read, or maybe try Victek tomato mod?
  5. enema

    enema Networkin' Nut Member

    That's what I'm using at the moment. Any suggestions? Because Tomato RAF can 'almost' do it as far as I can see. You can currently limit bandwidth per user, and also as a percentage, but I can't find a feature to dynamically correct it depending upon connected users. I'm certain there must be a way.

  6. Armand1234

    Armand1234 Addicted to LI Member

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice