BEFSR41, DMZ setting

Discussion in 'Cisco/Linksys Wireless Routers' started by Freelance, Mar 5, 2005.

  1. Freelance

    Freelance Network Guru Member

    Hi , im wondering if there is a way to DISABLE the DMZ feature on my BEFSR41 linksys router.

    At this point the interface only presents me with the choice of the DMZ host ip i want.

    Up to now i circumvinced the problem by putting a fake non used address but im wondering if its secure cause logviewer.exe reports lots of connection attempts to said ip adress. And all the common hacking ports at that too.

    So any way to fully disable DMZ or can anyone confirm that its safe to put a fake ip in there ?

    btw im using a bootleg firmware i found on some linksys related page
    1.46.02, Aug 03 2004
    seemed newer than what official linksys site offered. I think it was this site actually, just cannot remember.

  2. Freelance

    Freelance Network Guru Member

    Found out you can disable dMZ by putting 0.

    Oh well :)

    reading helps i guess /blush
  3. Toxic

    Toxic Administrator Staff Member

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice