Discussion in 'Cisco/Linksys Wireless Routers' started by bigjay517, Jul 26, 2005.

  1. bigjay517

    bigjay517 Guest

    I don't understand how to get UPnP to work. I have 1.05.00 firmware and I can't figure out how to enable UPnP I see the UPnP Forwarding but I have no idea what that is.
  2. itsmeohmy

    itsmeohmy Network Guru Member

    I too have BEFSR41 V3 1.05.00 so my box'es menu choices should match yours.

    Log in
    Select the upper tab: Administration
    Select the lower tab: Management

    Below the place you can change your log-in password is stuff for Remote Upgrade, and below that is the UPnP enable/disable radio-button choice.

    Don't forget to hit the Save Settings button on the bottom.
    Hope it works!
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice