Blinking Power LED

Discussion in 'Cisco/Linksys Wireless Routers' started by Slick_Nick, Oct 20, 2005.

  1. Slick_Nick

    Slick_Nick Network Guru Member

    Hello all. I'm having a problem installing the Linksys WRT54G Wireless-G Broadband Router V5.0. I have all the cables connected properly and the router powered up. The front of the router shows the WLAN, port 1 and the Internet LEDs lit up OK. However, the Power LED is blinking. I checked the Linksys knowledge database to find out how to fix the problem. It said that this blinking is caused by the firmware not loading correctly. The remedy was to download the latest firmware for WRT54G V5.0 and the firmware Auto Upgrade Utility exe file to install the upgraded firmware. However, there was no Auto Upgrade Utility file listed on the download page. There was just a zip file which contains the .bin upgrade file. My question is this. How can I upgrade the firmware without the Auto Upgrade Utility file? Any help and advice would be greatly appreciated. Cheers.
  2. Morpheus

    Morpheus Network Guru Member

  3. VadWiser

    VadWiser Network Guru Member

    also do not forget to put the wired network manually on 10half mode (i.e the lowest speed) while upgrading the firmware (after the upgrade you should put it back to auto or whatever the former was)...
  4. MaxiK

    MaxiK Network Guru Member

  5. Slick_Nick

    Slick_Nick Network Guru Member


    Hey thanks guys! I appreciate your help. I'll do what you suggested and see what happens with the router. Cheers
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice