block users by MAC or ip

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by billiumbuck, Mar 8, 2007.

  1. billiumbuck

    billiumbuck Guest

    Is it possible to block users based on MAC or IP address on a RV042?

    Using fw 1.3.1 but have seen the 1.3.8 upgrade.

  2. venom51

    venom51 LI Guru Member

    In the RV042 you will need to use the firewall rules to control traffic to and from users. There is no provision for MAC blocking that I know of in the unit.

    You should be able to accomplish traffic control by building a deny all rule for any traffic to and from the IP you want to provide traffic control over. Then create specific allow rules above the deny all for the traffic you want to allow to and from that IP.

    When setting up an RV042 I usually build a default deny all for all local lan traffic then specify allow rules for only what is needed.
  3. vpnuser

    vpnuser LI Guru Member

    RV042 supports MAC address filtering

    The configuration page is under DHCP/Setup.

    Attached Files:

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice