Bridge mode and port forwarding

Discussion in 'Sveasoft Firmware' started by Lloyd_a, May 31, 2005.

  1. Lloyd_a

    Lloyd_a Network Guru Member

    Does port forwarding work in bridge mode (Alchemy 1.0), and is it a valid thing to be trying to do?

    What I'm trying to do is access a device on the lan side of the bridge from the internet (http and telnet). The ports are forwarded from my (Netgear) router, to the wireless ip address of the Linksys, which I was hoping to use to port forward again (or is this double forwarding illegal?).
  2. kyouens

    kyouens Guest

    Bump. I am wondering about the same thing. Thanks.
  3. thevilla

    thevilla Network Guru Member

    Sounds 100% possible to me. Why haven't you tried it? (I don't use Alchemy though) :lol:
  4. HateEarthlink

    HateEarthlink Network Guru Member

    Have you created a static route in your Netgear pointing to your linksys?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice