Bridge mode with hyperwap

Discussion in 'Other Linksys Equipment' started by j79b, Mar 8, 2006.

  1. j79b

    j79b Network Guru Member


    First I've upgraded to 3.05 my two WAP54G and the bridge mode was running well !!

    But I had a bad signal so I've upgraded my access points with the hyperwap firmware.

    But since I've upgraded, the bridge mode is not working anymore.

    I've put the same canal (11) on the two access points and put the signal strong value to 84 on each material.

    Could you help me ?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice