Bridge Using WAP4400N APs

Discussion in 'Other Linksys Equipment' started by ryank007, Jul 18, 2006.

  1. ryank007

    ryank007 LI Guru Member

    Hello, I need to set up a bridge that I believe will be too far for G devices to work. Does anyone know if you can set two WAP4400N access points to work in bridge mode? If anyone has done this, does it work well? Many thanks in advance for the help!

  2. Toxic

    Toxic Administrator Staff Member

    have these even been released yet?
  3. ryank007

    ryank007 LI Guru Member

    Ah, good point. I saw it listed on Linksys' website, so I figured it was already released. I can't find it anywhere for sale, though, so you must be right. OK, next question then, can I use two WRT300N boxes and turn them into a bridge? (I'm guessing no.)
  4. Toxic

    Toxic Administrator Staff Member

    Well maybe Thibor can reply on that. he is working on a 3rd party firmware for the WRT300N as well speak. i dont know when it will be finished, but i hope it will be soon.
  5. G_Styles

    G_Styles Network Guru Member

    If your still wondering, the Linksys firmware dosn't support bridge mode.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice