Can I control Bandwidth or speed in WRT54GL

Discussion in 'Networking Issues' started by Akesh, Nov 6, 2007.

  1. Akesh

    Akesh LI Guru Member


    I have routor WRT54GL

    Can I control Bandwidth or speed in WRT54GL for each port ?

  2. danix71

    danix71 LI Guru Member

    With an alternative firmware. Take a look at Tomato (Thanks Lampi!).
  3. Akesh

    Akesh LI Guru Member

    very very Thank u

    It is OK now...:smile:
  4. Akesh

    Akesh LI Guru Member

    Is there any othere fireware for WRT54GL?

    Tomato is good , but it does not controal each port in seprated way!

    Tomato controles all ports with same speed !!


    I want it to control each port as I want ,

    for example,

    port1: should has 10KB/s

    port2: ................ 15KB/s

    and so on
  5. HennieM

    HennieM Network Guru Member

    I don't think you will find firmware where you can do that on the physical ports. A physical port is 10Mbit or 100Mbit, or 1000Mbit, as it has to do with the signalling rate of the electronics. However, you CAN control the transfer speed of different connected devices, by IP address, no matter what port or interface a device is connected to. This is known as Quality of Service (QoS). You have that in Tomato.
  6. Akesh

    Akesh LI Guru Member

    controling Ip is OK if it will do the same job which I want.

    How can I do that in Tomaro ?

    please , explain more Detail
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice