Cannot connect to wireless router after update to 4.20.7

Discussion in 'Cisco/Linksys Wireless Routers' started by ukblack69, Mar 12, 2006.

  1. ukblack69

    ukblack69 Guest

    Hello, i just updated my wrt54g from 3.03.6 to 4.20.7 and now I cannot connect from my wireless laptop. As I was going thru all my settings on the router I noticed that the WPA Pre Shared selection I used to use under Wireless Security has been replaced w/ WPA Personal,WPA Enterprise etc. Windows XP does not have an option for this in it's wireless network settings even after I updated it with the wpa udpdate on windows website. How can I get my laptop to work with this new encryption? Any help would be appreciated.

  2. columbians

    columbians Network Guru Member

    Try the WPA Personal and the TKIP combination on your router. Also, did you do a reset of your router after upgrading your firmware (by holding the reset button down for about a minute and then powering off and back on again)? Resetting is required to ensure that the firmware loads properly, but you do have to totally re-configure the router after this step. Does your wireless card have an updated driver on the web that you can download? Finally, have you tried WEP (just as a troubleshooting measure to see if it works--not as a permanent solution, since WEP is fairly easily hacked)?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice