Cannot establish an IPSec tunnel between two WRV200

Hi all,

I just bought two WRV200's for two remote sites and i'm trying to establish an IPSEC tunnel between them. Unfortunately i cannot do this although i followed the procedures in the manual step-by-step.

The configuration for Router #1 is:

VPN Tunnel : Enabled
NAT Traversal : Disabled
Local Secure Group (Subnet): 192.168.1.0/24
Remote Secure Group (Subnet): 172.168.1.0/24
Remote Secure Gateway: router2.dyndns.org

Key Exchange Method: Auto(IKE)
Operation Mode: Main
ISAKMP Encryption Method: 3DES
ISAKMP Authentication Method: SHA1
ISAKMP DH Group: Group 2
ISAKMP Key Lifetime (s): 28800
PFS: Enabled
IPSec Encryption Method: 3DES
IPSec Authentication Method: SHA1
IPSec DH Group: The group is the same as ISAKMP.
IPSec Key Lifetime(s): 28800
Pre-Shared Key: same as Router 2

The configuration for Router #2 is:

VPN Tunnel : Enabled
NAT Traversal : Disabled
Local Secure Group (Subnet): 172.168.1.0/24
Remote Secure Group (Subnet): 192.168.1.0
Remote Secure Gateway: router1.dyndns.org

Key Exchange Method: Auto(IKE)
Operation Mode: Main
ISAKMP Encryption Method: 3DES
ISAKMP Authentication Method: SHA1
ISAKMP DH Group: Group 2
ISAKMP Key Lifetime (s): 28800
PFS: Enabled
IPSec Encryption Method: 3DES
IPSec Authentication Method: SHA1
IPSec DH Group: The group is the same as ISAKMP.
IPSec Key Lifetime(s): 28800
Pre-Shared Key: same as Router 1

I disabled Firewalls and IPSec passthrough in both WRV's but no luck.

Is there something else that i must look after?

Thanks.

 

Hi,

Any suggestions???