Cannot flash new firmware on WAG54G

Discussion in 'Linksys Official Firmware' started by bulla80, May 25, 2005.

  1. bulla80

    bulla80 Network Guru Member

    I need some help guys, my WAG54G V 2 keeps dropping the internet connection< I have downloaded the WAG54G_AnnexA_ETSI_v1.03.0_beta4_00_code.bin firmware update and I am trying to upgrade through the web gui but it keeps comming up with the "upgrade is failed page", can someone please tell me what I am doing wrong or another firmware that will work currently I am using 1.00.19.
    Thanks in advance
  2. flipy

    flipy Network Guru Member

    You're trying to upload a V1.x firmware, however you have a V2 WAG54G router (ADSL2/2+ support).
    Try looking at your local linksys page for newest firmwares available.
  3. huntsman

    huntsman Guest

    Wrong firmware

    The revision numbers for these modems makes no sense at all!
    You are trying to load V1 firmware in a V2 modem. V2 supports the new ADSL2/2+ speeds up to 24Mbps and the firmware for it is V1.00.xx. Not sure what the xx rev is up to now. Last time I looked it was 32. (I think!)
    The WAG54G_AnnexA_ETSI_v1.03.0_beta4_00_code.bin firmware update is for a V1-V1.2 & will not work in a V2 modem, so I've been told by Linksys support staff.

    ..good luck...Keith
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice