Cannot get AG241 setup

Discussion in 'Other Linksys Equipment' started by auron476, Jun 21, 2008.

  1. auron476

    auron476 Addicted to LI Member

    Hope someone can help me as this is driving me nuts.

    I've just got hold of an AG241 gateway/router and despite resetting it several times I cannot access the setup page at

    Interestingly, when its powered up with nothing connected it the led's on ports 1 and 4 are solid green. When I connect my pc to either of those ports Win XP reports that 'a network cable has been disconnected'. Yet when I connect again on ports 2 or 3 Win Xp shows that it has a connection but I still can't access the gateway/router, even when I try to ping it's address it just times.

    Have I got a bricked gateway?

    Many thanks :)
  2. mstombs

    mstombs Network Guru Member

    The AG241 (v1 at least) accepts new firmware using the same tftp procedure as WRT54GL - only for a few seconds after power up. Might be worth a try.
  3. auron476

    auron476 Addicted to LI Member

    It's v2 model and I've just tried that method with no success :mad: My only option left is to try accessing the routers built-in serial console. Will let you know how I get on.
  4. mstombs

    mstombs Network Guru Member

    Guess you've already seen this site:-

    personally I would leave shorting flash chip pins as last resort - don't understand how it works and surely possible to damage the flash chip if you get it wrong!

    It should be possible to interrupt the boot with serial console
  5. CaNsA

    CaNsA Network Guru Member

    Is it a v1 or a v2, i have some firmware for it that u can tftp onto the unit, shuold fix it
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice