Can't Access Router After Changing IP on E4200 Toastman Tomato Firmware

Discussion in 'Tomato Firmware' started by Strutte2, Aug 5, 2013.

  1. Strutte2

    Strutte2 Reformed Router Member

    Good Morning,
    I recently flashed my E4200 V.1 firmware to Toastman's latest build (tomato-E4200USB-NVRAM60K-1.28.0502.1MIPSR2Toastman-RT-N-Ext.bin) and everything went smoothly. I did a 30/30/30 reset on the router and logged in to w/ admin/admin.

    Here, I enabled DHCP, named the 2.4GHZ and 5GHZ SSIDs, changed the admin password and enabled security. I am using an ATT Uverse modem/router in bridge mode with the wireless router disabled so I have to change the Cisco router IP to for this configuration to work. I did that and saved.

    My LAN internet and wireless internet are now working flawlessly at better speeds than the Cisco firmware, however now I am unable to log into the router at, I get an error that states the page is unable to load.

    I've googled the problem and other users experience the problem when they do not enable DHCP, however I'm unable to find a solution addressing this particular problem.
    Thanks in advance for any help on the matter.

  2. Marcel Tunks

    Marcel Tunks Networkin' Nut Member

    Did you change your computer back to either:

    1. Automatically obtain IP address from DHCP?


    2. Change to new subnet for your new router (192.168.2.x)?
  3. Strutte2

    Strutte2 Reformed Router Member

    I changed it back to #1, LAN would not connect to Internet otherwise.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice