Can't Access Router

Discussion in 'Tomato Firmware' started by unibonger, Mar 3, 2011.

  1. unibonger

    unibonger Networkin' Nut Member

    I enabled HTTPS for local connections to the router, and since then I can't connect via wireless or wired. Tried hard resetting to no effect.

    Was just curious if anybody had any ideas around it? Or did I just permanently lock it into these settings?

    Thanks much in advance.
  2. minimeme

    minimeme Networkin' Nut Member

    i did the same thing a couple days ago. the s at the end of http wasn't showing up in address bar. had to manually put it in there.
  3. TT76

    TT76 Networkin' Nut Member

    Telnet into your router,and then input the commands below:
    nvram set http_enable=1
    nvram set https_enable=0
    service httpd restart

    then access web via http and change access mode back to http access.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice