Can't Access WRT54GC after DHCP Disable

Discussion in 'Cisco/Linksys Wireless Routers' started by stoneyos, Apr 10, 2006.

  1. stoneyos

    stoneyos Guest

    Can anyone tell me how to access the setup screens after disabling dhcp on the router. I was going to try to use it as an access point but after I disabled DHCP I could not get back into it. Someone had previously assigned the router's IP as and it is set to obtain DHCP IP from ISP.

    Also it seems that the reset button is not functioning. Is there a way to force a reset through jumping the ports?
  2. RTSAnime

    RTSAnime Network Guru Member

    You have to manually set your ip address to something in that range (ie and then you will be able to access the internet or you can hold the reset button on the router down for 30 seconds. Doing so will reset it to all factory default settings
  3. jgutz20

    jgutz20 Network Guru Member

    also set the DNS and Gateway to the IP address of the router, subnet mask of
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice