can't connect from Windows wireless client

Discussion in 'Tomato Firmware' started by belm0, Dec 29, 2008.

  1. belm0

    belm0 Addicted to LI Member

    Running Tomato 1.23 ND on Asus gl500-gpV2 with default settings. Works fine except for Windows wireless client. I can connect to wireless from Linux on the same machine, and also from clients on Mac, G1 phone, etc. The Windows client just gives up without logging an error-- however I can connect to neighbor's networks with no problem, so I'm sure this is a router config issue. I've tried disabling all authentication, no luck. Completely baffled...
  2. mstombs

    mstombs Network Guru Member

    Intel Wireless adaptor?
  3. belm0

    belm0 Addicted to LI Member

    Yes, Intel PRO/Wireless 2200. Works fine from Linux.
  4. Toastman

    Toastman Super Moderator Staff Member Member

    Try setting a fixed IP address .... this often works with 2200BG cards, but perhaps not with the ND driver. There'a a lot of stuff on this forum - search for "2200BG"
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice