Can't connect to my Canon Printserver after upgrading to tomato 1.19

Discussion in 'Tomato Firmware' started by SirAdam2k, Jun 23, 2008.

  1. SirAdam2k

    SirAdam2k LI Guru Member


    after upgrading to tomato 1.19 I can't connect to my Silex C-6700WG with the "SX Virtual Link" software. I need this device and the software in order to use my Canon MP750 as a scaner and printer in the LAN. The software shows that the MP750 is present but when I try to connect to it, it just won't happen. There is no error message or something and no log.

    On the other hand when I try to find the C-6700WG over the WLAN it doesn't shows up.

    But I have access from my pc to my shared folders on the WLAN device.
    I really can't see why it is not working.

    Any suggestions?

    Thanks in advance :)
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice