Case Study: Remote Access Point and Bridge

Discussion in 'Sveasoft Firmware' started by adoti, Aug 1, 2004.

  1. adoti

    adoti Network Guru Member

    I have just purchsed a WRT54G and loaded the Satori-4.0 v2.071.7sv firmware. All boots up fine and look good.

    My goal is to put the WRT54G in the living room and connect my XBOX, ReplayTV etc... to the ethernet ports and use the wirelss connection to bridge to the office where by D-Link wireless router is located and the main internet connection.

    I can't figure out what combination of settings I need to perform on the WRT54G in order to get it to attach to my current wireless network and allow my remote components to get online.

    Anybody done something simular?
  2. Couledouce

    Couledouce Network Guru Member

  3. Waruwaru

    Waruwaru Network Guru Member

  4. commanderx

    commanderx Network Guru Member

    I have connected my Xbox to a Netgear ME102 AP which is in Bridge Mode connected to the WRT54G.
    I followed the 'official' Sveasoft Documentation for WDS, except that i havent disabled the Firewall.
    And it works fine.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice