.cfg file migration 2.0b3 -> 2.0

Discussion in 'HyperWRT Firmware' started by boiler, Feb 9, 2005.

  1. boiler

    boiler Network Guru Member

    I'm using HyperWRT 2.0b3 at the moment and everything is working really well.
    If I migrate to 2.0 can I use the 2.0b3 config file to restore my settings?.
  2. Morpheus

    Morpheus Network Guru Member

    Yes i did the same thing works ok.
  3. dellsweig

    dellsweig Network Guru Member

    You should NOT have to do a restore of your config. Just upgrade your firmware and all of your settings will be there
  4. Toxic

    Toxic Administrator Staff Member

    quote from linksys.....

    it is always best to reset the route. then reload the cfg. the cfg should however only be used to restore similar versions of firmware. any major changes in firmware then reset router and manually setup router again.
  5. boiler

    boiler Network Guru Member

    Thanks guys. Figure the versions are close enough for it to work.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice