Changing firmware. HOW??

Discussion in 'HyperWRT Firmware' started by anectine17, May 2, 2006.

  1. anectine17

    anectine17 Network Guru Member

    OK...I've looked everywhere. I've given up on my's a brick...smoke and all. Anyway, I have a WRT54G ver. 2 that currently has HyperWRT on it. I'd like to switch to DD-WRT. The DD-WRT instructions say to switch back to Official Linksys before flashing with DD-WRT. How do I do that ?? I've looked and I'm at a loss. Thanks.

  2. NateHoy

    NateHoy Network Guru Member

    Download the standard firmware from for your router, go to the firmware upgrade page, and select the file you've downloaded.

    Then you'll be on Official Linksys, and you can load DD-WRT from there.
  3. anectine17

    anectine17 Network Guru Member

    Thanks.....for some reason I thought there was more to it. All done and running on DD-WRT now. I was a little gun shy after bricking my GS this morning.
  4. myersw

    myersw Network Guru Member

  5. anectine17

    anectine17 Network Guru Member

    Thanks for the reply. I was well past that debricking procedure when all the LAN LED's and the SES button LED's came on and stayed on....along with the still flashing power LED. I've tried all of the pin shorting tricks I can find. I'm pretty sure it's dead. Thanks again.
  6. Thibor

    Thibor Super Moderator Staff Member Member

    flashing power and all other led's solid is not a good place to be in, i have had a couple of router's like that(they are hubs now) that were unrecoverable
  7. grcore

    grcore Network Guru Member

    HI, I would be interested in a bricked unit to investigate recovery options. I can pay for shipping, if you are interested, and if am successful you can have the unit back.

    Let me know, Thanks

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice