Cisco RV120W VPN help

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by andy t, Feb 10, 2014.

  1. andy t

    andy t Reformed Router Member

    I have two sites each with a Cisco RV120W Router in each. My objective is to establish a VPN between the two routers so we can map a shared drive between both locations. I have been successful in getting the IPsec tunnel established between the two locations and can remotely log into the far end router with no issue.

    The problem I'm having is I can't access the far end PC. I am not using PC names but rather their local IP address. It's like the router is not passing traffic to the remote PC.

    I am missing a setting somewhere?
  2. DocLarge

    DocLarge Super Moderator Staff Member Member


    I'm guessing you've figured this out by now; my first thought would have been to check and see if the end PC you were trying to access had a personal firewall running.

    If that wasn't the case, what was your solution? Let's try and get back into practice of sharing solutions with the other members in the event they run into the same problem in the future... :)

  3. Sfor

    Sfor Network Guru Member

    Indeed, the firewalls tend to block the traffic comming from another subnet, by default.

    Other thing to check is if the local and remote security group settings are proper.

    The first thing to do is to get the ping answer from the remote PC.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice