CIT200 And Tomato Firmware

Discussion in 'Tomato Firmware' started by Zeknichov, Oct 30, 2008.

  1. Zeknichov

    Zeknichov Guest

    I can't seem to get my CIT200 to work using tomato firmware. If I make a call I just get a busy signal (the same signal I would get were the CIT200 showing disconnected not connected.) If I reset my router back to the default linksys firmware the CIT200 works, so it is something to do with Tomato firmware. Any help would be appreciated.
  2. azak

    azak Addicted to LI Member

    This is very weird considering that CIT200 is not a network device and just talks to Skype. Does Skype by itself work properly with your tomato router?

    For the record, I use a CIT200 with a tomato router. Everything just works, no configuration was needed.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice