Client Bridge on DD-WRT 7/10/2005

Discussion in 'DD-WRT Firmware' started by JohnSK, Oct 10, 2005.

  1. JohnSK

    JohnSK Network Guru Member

    Hi ppl,
    I am planning to update my DD-WRT running on my WRT54G's. (in a few hours actually) Currently I am using WDS with WPA PSK (AES) which works. I would have used CLIENT BRIDGE mode but WPA wasn't working properly in the 19/9/2005 build of DD-WRT.

    Now I read a lot of posts with mixed results and thus would like to ask whether or not WPA (or WPA2 preferably) now works on the latest DD-WRT build in CLIENT BRIDGE mode and on which HW version of the WRT54G. (I have v.2.2)

    THANK YOU very much in advance for help!

  2. JohnSK

    JohnSK Network Guru Member

    Well.. no reply so.. I did it myself, WPA support is still flaky so WDS is the only option so far
  3. hotrat

    hotrat Network Guru Member

    doh :( will give it a try wif 10.10 today mate
  4. BrainSlayer

    BrainSlayer Network Guru Member

    not flaky, but it can take up to a minute till the connection is established
  5. hotrat

    hotrat Network Guru Member

    still not working in 10.10 for me on a GS 1.1. altho i must admit i did not wait a minute for it to work because it already showed as connected under wireless status, just no data throughput

    Updated: waited 10 minutes for it and STILL NOT WORKING, it shows connected under wireless status etc.. NO DATA THROUGHPUT however..

    @BrainSlayer wot exactly are the differences in how CLIENT BRIDGE is implemented between V23 and HyperWRT (by Thibor)???
    works perfectly for me using HyperWRT and WPA but not V23!!
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice