Client-To-getway setup on RV042

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by phat_3, Oct 29, 2007.

  1. phat_3

    phat_3 LI Guru Member


    I'm trying to setup My RV042 to enable client-to-gateway VPN but can get it to work. Search the net for tutorials but all the ones I've founded were for gateway-to-gateway.

    I would like to know if someone has a step-by step guide for the setup or an example I can use. My internal address subnet

    The VPN client is going to be the QuickVPN by linksys

    Thank you
  2. vpnuser

    vpnuser LI Guru Member

  3. phat_3

    phat_3 LI Guru Member

    No good!!!!
  4. Toxic

    Toxic Administrator Staff Member

    you dont use Client to gateway for QuickVPN. Use the VPN Client Access page to setup your Clients and make sure HTTPS is enabled in the firewall page. you the connect QUICKVPN using the username/pwd setup in the client access page and using the WAN IP address or FQDN
  5. saboIT

    saboIT LI Guru Member

    Same problem for me

    I am having the same problem. I have a laptop behind a pfsense nat firewall.
    I am trying to connect to the RVO42 with a static IP address. I was trying to connect with the linksys VPN Client from behind the firewall (non routeable IP) to the routable IP address of the RVO42. Then i read the reply and tried that but it is still not working. Does anyone have any ideas? Is my understanding flawed?:thumbdown:
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice